A few questions before RGB modding my NES

Hi there assembler!

I have a few questions before I order a RGB kit from Etim.
I am starting to play more and more NES, but the composite quality is just horrible.
Therefore I have been looking at this RGB board from etim´s store: Link.

However, I am not sure what to do about cables?
I live in scart region, and was planning on using that as my connector, but both sets of scart cables are sold out on Etims store: Link.
Is there an alternativ to something I could use when not owning a framemeister (yet).

Thanks!

- Madsmaten

 

you can do a variety of things, such as go with the SNES style multi out and use and SNES scart cable. since you can use any connector you want.

 

Can I buy that connector seperately?

 

check with Helder, he should have some left hopefully. this will make your life MUCH easier.

 

Could I buy this component kit -> http://etim.net.au/shop/shop.php?crn=203&rn=549&action=show_detail
And then use something like this -> http://www.ebay.com/itm/3Ft-HDMI-to...782337?hash=item1ead6f7781:g:8-oAAOSwY45UTeCN
Since my tv does not support 240p over Component.

 

Your TV would need to accept analog over hdmi....

 

And it won't I take it it doesn't do 240p over RGB either then?

In that case you should get an RGB or component to HDMI transcoder that does support 240p. A Framemeister or OSSC would be the best choices, but there are cheaper alternatives, although with usually much worse results.

 

Whatever you do, don't use use that included din connector.. It's garbage