I've been trying for hours and I can't seem to figure this out. I've used a mix of debug, retail, hacked and my own compiled images that run fine when flashed, but refuse to run as a BFM bios. All but my own I have acquired as pre-converted BFM images. I've tried a few versions of PBL, and it gets to "calculating 2bl entry point" and just stops. The stripped down versions just go to a black screen, change the LED sequence and jam up. I tried the Metoo version of PBL too just in case, but it was acting the same. Any ideas on what I can try? I'm on a v1.1 console with iND 5003 and unleashX installed using Hexens. Not sure if having the virtual C drive and virtual EEPROM will cause a problem, as PBL should be booting the current kernel out of memory, and the replacement should have raw access again.
