Got a PS3 slim with dead bluray for $30, added a hard drive and got an error.

Discussion in 'General Gaming' started by ASSEMbler, May 20, 2012.

  1. ASSEMbler

    ASSEMbler Administrator Staff Member

    Joined:
    Mar 13, 2004
    Messages:
    19,394
    Likes Received:
    995
    "The system software cannot be run correctly. Press the PS button to try to restart the system. If the system cannot be restarted correctly, the system partition of the hard disk must be reformatted and you must reinstall the system software. Insert storage media that contains update data 2.35 or later then press the start and select buttons at the same time"

    I don't want to install the current 4.10 firmware, I bought this old junker so I
    can run it as a media center.

    Any idea where I can get the OLD files for repairing this error?
     
  2. Jamtex

    Jamtex Adult Orientated Mahjong Connoisseur

    Joined:
    Feb 21, 2007
    Messages:
    5,472
    Likes Received:
    16
  3. Cyberghost

    Cyberghost Peppy Member

    Joined:
    Feb 19, 2010
    Messages:
    378
    Likes Received:
    6
    didnt the slims come out with 3.00 on them? I personally wouldnt feel ok putting a software on it thats older than the hardware.
     
  4. ASSEMbler

    ASSEMbler Administrator Staff Member

    Joined:
    Mar 13, 2004
    Messages:
    19,394
    Likes Received:
    995
    It's got 3.66 on it. Ffffffffffff
     
  5. Keberasky

    Keberasky Spirited Member

    Joined:
    Mar 18, 2009
    Messages:
    102
    Likes Received:
    2
    The best respectable site that I would get this from is ps3devwiki.com. It does appear to be down at the moment though. You can also get this file from the usual hack sites (PS3hax, or....PS3news *shudder*).
     
  6. HEX1GON

    HEX1GON FREEZE! Scumbag

    Joined:
    May 4, 2011
    Messages:
    9,916
    Likes Received:
    837
    Ahhhh boo :<
     
  7. Bad_Ad84

    Bad_Ad84 The Tick

    Joined:
    May 26, 2011
    Messages:
    8,566
    Likes Received:
    1,311
    Downgrade
     
  8. pool7

    pool7 Site Supporter 2014

    Joined:
    Mar 4, 2008
    Messages:
    1,268
    Likes Received:
    134
    Mine came with 3.66 as well... when I started looking into the downgrade process, well... too complicated, and more expensive than expected. Plus, it's not guaranteed to work for FW over 3.60 IIRC...
     
  9. ASSEMbler

    ASSEMbler Administrator Staff Member

    Joined:
    Mar 13, 2004
    Messages:
    19,394
    Likes Received:
    995
    I'll probably wind up throwing it on ebay.

    it took the 4.10 fw and works, just needs a hdd and laser. A bit
    too much work for me to care.
     
sonicdude10
Draft saved Draft deleted
Insert every image as a...
  1.  0%

Share This Page