Hello, I had a spare FT245R and I figured I should install it on my Everdrive. I already install both 0ohms resistors on USB signal lines, 0,1uF on VCC and VCCIO and the 10Kohms on PWREN#. Now I am missing 2 components for driving the RESET signal. Normally I would just pull this one to VCC with a 10Kohms but the FPGA is controlling that signal. So by referencing to the picture below, which components and which values should I install on the left and right sets of pads? ED64 FT245R Thank you!
Hello, I have soldered all the components and the FT245R is detected by my computer. I even changed the Description and the Serial Number of the FT245R so it displays "Everdrive 64 v1.01" as the description and "64ever" as the serial number. I tried to load a rom through the loader executable but I get a "ED64 usb port not denected" (there is a typo in the program itself). I took the executable straight from Krikzz website in the ED64 section. I was wondering if there was some special info I should write on the FT245R for the loader64.exe to recognize my cart... Thank you!
