Hooked up my Dreamcast Dev Kit today and need some help

Discussion in 'Sega Dreamcast Development and Research' started by coreycorey2000, May 3, 2006.

Watch Thread
  1. coreycorey2000

    coreycorey2000 Spirited Member

    Joined:
    May 31, 2004
    Messages:
    180
    Likes Received:
    0
    I finally picked up a scsi cable. So I decided to try to hook up my Dreamcast Dev today. I had some luck but then it stopped all of a sudden.
    I hooked everything up like I'm supposed to. Powered on the Dev Kit. Then powered on my computer. I recieved this message
    ID 3: CPL KATANA DA

    ID 4: CPL GD-M

    Then nothing happens. And I get a black Screen.
    I installed the Adaptec 2940 Driver. But I don't have an SDK yet. Would that be my problem?

    If any one could shed some light on this. I would greatly appreciate it.
    Thanks
     
    coreycorey2000, May 3, 2006 Report
    #1 + Quote Reply
  2. ASSEMbler

    ASSEMbler Administrator Staff Member

    Joined:
    Mar 13, 2004
    Messages:
    19,394
    Likes Received:
    995
    Your pc has a conflict, the pc should boot up first of all.

    You need check your scsi devices (if you have a few, the id), disable any sata devices, and
    change it so the system isn't trying to boot from the katana.

    My suspicion is it's looking for the os on the unit.
     
    ASSEMbler, May 3, 2006 Report
    #2 + Quote Reply
sonicdude10
Draft saved Draft deleted
Insert every image as a...
  1.  0%

Share This Page