Dear How to set up XP mode on my W7 integral (64 bit) for use XBOX XDK, especially Xbox neighborhood. I succes to install Xbox XDK, and I block IP address on my xp mode (192.168.0.1, 255.255.255.0...) and block IP address from Win 7 (other address....) but my Xbox dev kit dont recongnize.... Thanks
Make sure the network connection is bridged and not natted. Copy and pasted from http://blogs.technet.com/b/windows_vpc/archive/2009/09/26/networking-and-using-windows-xp-mode.aspx Networking a Windows XP Mode VM The default network setting of Windows XP Mode is NAT (Network Address Translation), but you can change it. NAT allows the host machine to act as an agent between the external network (e. g. Corpnet or Internet) and the VMs running on that host. The network will use the host's IP address itself, which represents the group of VMs on that host, to communicate with the VMs. The host can resolve the network packets to the specific VM they are intended for, using port numbers. This is why, the Windows XP Mode VM, using NAT as the default configuration, is ready to connect to the network upon first launch. However, note that the network communication has to be initiated first by the NAT configured VM. In VM settings in Windows XP Mode (Fig. 1), you can specify up to four emulated network adapter options, which can be assigned to any network card installed on the physical computer. To change this configuration, the Settings dialog box shown in Fig. 1 can be accessed using ‘Settings’ option under ‘Tools’ element from the VM Window’s toolbar. When you click on the ‘Networking’ setting, you will find the following four options to choose from: Shared Networking (NAT) option shown in Figure 1 (Left) refers to a virtual NAT (Network Address Translation) which allows the VM to leverage the external TCP/IP network connected to the host. This is very useful if you regularly move the host computer between different network configurations. NAT is the preferred networking option when there is a shortage of IP addresses, a need to ensure the VM’s IP address is not targetable from an external network, or a need for connecting using WWAN. In contrast, Bridge mode uses the network adapter on the host. This option appears in the drop down menu as the name of the adapter. In Figure 1 (Right), it is shown as Intel® 82566DM-2 Gigabit Network Connection under Adapter 1. The VM is connected directly to the selected network connection of the Windows 7 host, and will behave like a separate physical computer on the same network. If the host has a wireless adapter, its name will appear in the dropdown list. In Bridge mode, Virtual Machine Network Services driver helps redirect the incoming network traffic to the correct VM and associate the correct MAC address in all outbound network traffic. In scenarios using VPN, Bridge mode is the preferred option. Choosing the option ‘Not connected’ disables the VM’s networking ability and completely isolates it from the network. ‘Internal Network’ option enables networking among only the VMs on the single Windows 7 host. Figure 1. Settings dialog box to configure a VM’s networking adapters as (a) Shared Networking (NAT) on the Left, or (b) Bridged mode on the Right Windows Virtual PC (WVPC) emulates up to 4 DEC/Intel 21140A-based Ethernet cards per VM, each with its own unique MAC address. WVPC translates the instructions executed by the Windows XP network driver into network activity. Because the packets are handled as Ethernet packets, WVPC is protocol agnostic and can support protocols other than TCP/IP. All VMs connected to a specific virtual network can access traffic sent from and received by any other VM on that same virtual network.
Magnifique, thank you very much, it's run very well, in XP mode network setting i selected Bridge mode, then I block ip address always in XP mode. the best, no need to modify network setting in Win 7. Thanks you very much.
