Well first of all I wanted to comment that this staff little project got much time that I have been developing work in free time is not in fact be very difficult to make but because I wanted to fulfill certain characteristics because if I took some time now I share and if anyone wants to do it I assure you that is not difficult and will result is a small magnificent reader directly using Micro SD adapter without using ... Method and Materials: - PORT Micro SD can remove a multilector they are very cheap - The SERIAL PORT CONNECTOR: you can do with an AGP port as we have seen in the forum - Copper plate for recording circuits - Or some other ferric acid which serves to remove copper - Couche paper - Drill drill holes in printed circuit boards - Thinner or acetone to remove ink toner - Iron - All components needed to keep it going for the sd reader; 47mF electrolytic capacitor, resistor 470ohms (1/4 watt) LED any color we like, and ceramic capacitor of 100 pF .. - Patience patience .. PRINTED CIRCUIT BY THE METHOD OF IRON ... 1. First we have to print the circuit on paper Couche "Eye" serves no other role I try the photographic but did not work with me and less common paper, another requirement for this method to work is that debemore make the impression on a lazer printer toner ink we are using public photocopiers "NO" we serve if you print to a printer inkjet this method will only work with the ink toner like as copiers ... This is how is the impression, also you can see the plate to record the PCB. 2 To print should be with the paint or some other program that allows us to print at 100% without resizing the image and the size must be exact. In paint must go to PRINT> PAGE SETUP then, then we select the following options are not selected by default first SET TO 100% and mark the horizontal and vertical boxes for the print is centered. And with that we can now whether to print. 3. How to make the PCB; Here I give you a video as should the PCB This is how is the PCB after using the acid to dissolve the copper. We select the best was printed circuit .. To cut what we can do with scissors for sheet or a zegueta and sanded the edges to give a better finish with a file or sandpaper .. This is the end result and with ready made for soldarle ahujeros components. 5. To remove the SD PORT multilector they put a picture that explains use a razor or a cutter and introduce between the plate and the port and then we give paw paw heat until it comes out the SD port is not difficult but it must be easy to avoid workpiece burn or damage by we force ... 6. SERIAL CONNECTOR can be manufactured with an AGP port as it was discovered Dreamcast.es forum here I leave the LINK: http://www.dreamcast.es/forum/view...f we want to do here to help .. !!!! .... o_o
Nice work, and holy hell, building your own serial contact from an AGP socket takes some serious dedication!
