Snes No IMAGE?

Hey! i accidently took my multimeter on the snes voltage regulator ground to ground, and my snes died.
I replaced the fuse and its alive again but no image after the accident?

Anyone have a clue?

 

Are you getting 5v on the voltage regulator.

 

how do i measure that? i have a multimeter!

i got 26v and 10v on voltage regulator

 

Are you really getting 26v?

I would just change out the voltage regular and hope your snes is not fried.

 

On input i got 26v and output 10v
Before V regulator i got 10v strange isnt it?

 

The snes takes 5v internally so change out the voltage regular.

 

The snes psu is unregulated, so with no load the voltage will be much higher than the 10v or so it's supposed to be.

 

Ok so can we certify the regulator need to be replaced?

 

The whole console probably needs to be replaced.

I assume when you say "no image" you actually mean no image, sounds, or anything else.

What did you actually short out?

 

The red lamp on the console is on! I accidently took My multimeter fr.o.m. Ground to ground on the voltade regulator.

 

Ground to ground wouldn't do anything.

 

myehhhhhhh

 

I think i linked something on the regulator with the multimeter...

Anyone?

Hello again! I had the wrong setting on My multimeter i got 10.1v on imput and 4.95 on output so the V-regulator seems to work. Still no image?

Is it big chance that the caps are the problem? I think i accidently bridged ground and R on the voltage regulator

Here is a video on the dilemma

 

i thought this thread was just a joke at first. the 26v made me laugh a little.

have you had a good look around the motherboard for damage? any black marks anywhere, raised caps etc?

 

Here is a link to the motherboards, same problem on both!
the 1 one was working but i accidently bridged ground and the right leg of the 7805 regulator.
http://www.ladda-upp.se/bilder/jmcdnwjcggoxud/
http://www.ladda-upp.se/bilder/gjrboaitxgrhks/

anyone

 

Erm, its not clear in the video, but, you have a game in the system right?

 

Also have you installed a supercic or anything like that? If so, did you remove the original CIC?

If yes to both, did you install the 10kohm resistor required to stop the console being stuck in reset?

 

Please stop bumping your thread when no one replies in short intervals... I've merged all your posts. Edit if you have to.

 

I have no supercic, and ofcourse i have a game in the cart slot.