Super Aladdin XT Issues, Help needed

Just recently got my order from bad_ad84 installed the xenogc into my GC and works flawlessly but im having some issues with my Xbox v1.2/v1.3.
I installed the pin header (Removed the 1 pin from the second row to fit it), Did the bt always on and d0 connection, turned it on and theres no Evox logo.
is there something im missing?

 

If its booting the original bios, your D0 point is wrong (thats what disables the on board bios)

 

Thank you dude, Im going to try to find the actual "d0" point tomarrow i'll be sure to update.

 

http://www.x-elixis.com/final/installation/do-point.htm

The underside is easier to solder to. Just wire it to the ground around a screw hole.

 

Just got around to installing it to the "d0" underneath still nothing. could it be something else? maybe something with the pin header? i installed all the points on the pin header ive seen guides with points left out

 

If you've actually grounded d0 that XBox will either boot from the modchip or FRAG. It will not boot from the original BIOS unless d0 is improperly done.

 

Time to take pictures of your install, might be easier for people to help you out.

 

will do give me a couple mins.

 

Sorry about the quality of the pics i tried. soldering is not the greatest but it has worked with every mod so far

 

connect d0 from the xbox motherboard to a ground point on the motherboard (like APE said). Then try booting the console without the chip - it should frag (so on board is disabled).

Once you get to that stage, connect the chip. The d0 point on the chip doesnt need to be connected to the motherboard if you have already grounded it. Then see what happens

 

Alright i connected d0 to the screw plate (where you put the screws on the board - Ground plain?) no chip = frag, with chip = frag

 

Ok, so d0 is done properly now.

That just leaves installation issue or chip fault.

can to remove the wire for BT (leave it connected on the chip, but I see you are running the wire elsewhere.

 

Ok, i removed that second wire for BT still its a no go (frags). im not sure if this is apart of the xbox fragging sequence but does it turn on and off twice then red/green lights flashing?.

All thats connected right now is chip in the pin header and the bt always on wire

 

Are you holding down Power? I think that's how you activate the chip... (apart from installation errors, I can't help you there) but try doing that.

 

Yes, thats normal fragging sequence.

I will send you a PM shortly.

 

Correct position of chip


Incorrect position of chip

 

*facepalm* wow i feel like a dumbass xD. thank you jinn. works now thank you guys for helping me out