Wanted: Xbox Debug Or Xdk

im on the market for an Xbox debug or xdk system so "IF" anyone has a spare on please le t me know

Thanks

D

 

What price range and country are you looking in?

 

USA as for price i believe its up to the seller with in a reasonable price range ofcourse :-D if its an ACTUAL clear debug i would hope it has an original clear controller considering i am low stock of controllers

and if it happens to have dev titles please do not disclose her pm me thank you all for helping me in getting my collection going i owe you all!:dance:

 

http://assemblergames.com/forums/showthread.php?t=11281

 

hey alan

PM sent


Im STILL lookinging

 

UPDATE

XDK DVT-3 If possible..................................

 

Mail box full :nod:

I am sure it is PAL but you can change the settings to NTSC anway

Just have to do something about the power supply

This has never been opened at all, all still minty fresh :thumbsup:

 

Alan Clean out your mail if you can tell me about what to do about the power supply then consider it SOLD!!!!

 

Remove 6 screws from bottom of the casing to take off the plastic lid. Unscrew the additional PCB boards above HDD, remove HDD & DVDrom and expose motherboard and PSU. Carefully remove the PSU strip connector, 2 small screws and slide out UK 220-240v PSU, replace with correct US 110v PSU and reassemble in reverse order. Taking care not to kill either yourself or the DVT-3 via either static or by having anything plugged in whilst mucking about with it.

A 15min job for someone who's never done it before. I assume (VA or OE correct me if I am wrong as I have no DVT-3) it is the same type of PSU as found in the V1 retail Xbox and DVT-4.

Or, buy a UK / US power convertor to avoid opening the unit.

;-)

 

Why Hello Parros

i thank you for that infomation!

 

DevGuy you, yourself need to clear out some of your PM's, youve got too many in your inbox and no one can message you.

 

hey all

************DELETED ALL NOT NEEDED MAIL***************


Send me mail ^^

 

There you go

Sorry tried to reply to your mail but your box full....mine is fine

OE is the ORACLE on this if you want to check with him

 

To: Parris

Yes Parris i agree....well for the most part the job in question is more like a TEN minute job LMAO again i thank you parris again

 

You are more than welcome ;-)

 

And if you do change out the psu you can use a hair dryer to heat up the bottom stickers and carefully peel it back enough to expose the screws.

 

Hey all

Still Looking. . . . .

 

Hey Devguy , please check your PM. If not interested plz let me know also, so i can look at other buyers.

cheers
tubo