Announcing the 64drive nearing completion

Any chance you could just have a chip socket for the CIC chip like on the flash carts and use a 2 pin jumper connector in place of a soldered jumper for the for the 6105?

 

i'd be interested in one too, good work mate

 

good work! defo interested

 

it fits on a flash cart?

 

A socket should fit as long as there is no metal shielding like in the real gamecarts.

I made this some years ago:

Still did close without problem as long as you leave metal shielding out.

 

yeah there's no metal shielding on a flash cart so that's why it fits. but yes a socket plus a cic chip should fit.

 

I was just interested if it's supported because all my stuff is patched to run on a Doctor V64 and I'm too lazy to dump my games over again ;-)
Seriously, I absolutely agree with you. It's important to support clean dumps. And currently I do not know any good reason to support the DS1.

Anyway it would be very nice if you could add support for Dezaemon 3D. Some cartridges contain self made shooters and it would be great if we could share such data.

 

I'm just too excited for this! I need one! ray:

 

as previously stated many times, I'm down for a cart or two

 

I would be interested in one pending price! Great job! Also I'd be interested in the doing the community purchase that was mentioned as well.

Thanks
Disjaukifa

 

Definitely should see about this.

 

I agree, I'm definitely interested in this. Heck, I /might/ even buy two.

 

I would definitely purchase one to replace my aging v64jr

 

I'd be down for one, but only mid-January as my funds are low for various reasons. Stupid car.

 

Has the been a ballpark price been quoted?

-Disjaukifa

 

http://www.assemblergames.com/forums/showpost.php?p=456884&postcount=10

 

Thank you!

 

Not a problem.