PSX MM3 modchip... alternative trace for pin 4?

Take a photo and show it to us. We can help better
BTW i see alot of modchip install that used very loong IDE wire ( a disaster of mod :disgust with lifted trace on mobo but works the same...

@Jinn: can you send mayumi 3 hex to me? I would test and find installation too

 

Here's some pictures of the install: http://imgur.com/a/2nFTX The chip is normally held down with a strip of Scotch tape. I did NOT have the metal shield attached when I tested Strider 2, if that makes a difference. I can retake pictures or label them if needed. Thanks everyone for offering to take a look

 

Installation it's a mess!
Make wire shorter and, if i see correctly, point 3 it's in wrong solder pad
You should solder it to the next right pad

 

yes, point 3 is in the wrong place.

good looking out master

 

I got it working! I had to move point 3 to the correct location and shorten it's wire. I also shortened and re-soldered point 7's wire to be safe. Tested it with Strider 2 and it works great!

Thanks for the help everyone! Thank god I never tried to install a PS2 modchip :cringe:.

 

Glad i've helped you