Snes mini power scematic

Discussion in 'Repair, Restoration, Conservation and Preservation' started by retronerd, Dec 28, 2015.

Watch Thread
Page 2 of 2
  1. retronerd

    retronerd Spirited Member

    Joined:
    May 6, 2012
    Messages:
    156
    Likes Received:
    5
    OK! So just one wire in each hole and solder on both sides? Thanks again
     
    retronerd, Dec 28, 2015 Report
    #21 + Quote Reply
  2. Bad_Ad84

    Bad_Ad84 The Tick

    Joined:
    May 26, 2011
    Messages:
    8,566
    Likes Received:
    1,309
    yes, wire completely down and through to the otherside, then you can solder it on both sides to make the connection
     
    Bad_Ad84, Dec 28, 2015 Report
    #22 + Quote Reply
  3. retronerd

    retronerd Spirited Member

    Joined:
    May 6, 2012
    Messages:
    156
    Likes Received:
    5
    does it matter if i bridge it if its on the same row?
     
    retronerd, Dec 29, 2015 Report
    #23 + Quote Reply
  4. Bad_Ad84

    Bad_Ad84 The Tick

    Joined:
    May 26, 2011
    Messages:
    8,566
    Likes Received:
    1,309
    No, it doesn't matter if on same row.
     
    Bad_Ad84, Dec 29, 2015 Report
    #24 + Quote Reply
  5. retronerd

    retronerd Spirited Member

    Joined:
    May 6, 2012
    Messages:
    156
    Likes Received:
    5
    Its ALIVE:) Thanks Bad_Ad84 for all the support couldnt have done it without you:)
     
    retronerd, Dec 29, 2015 Report
    #25 + Quote Reply
    Helder likes this.
Page 2 of 2
sonicdude10
Draft saved Draft deleted
Insert every image as a...
  1.  0%

Share This Page